A practical gait feedback method based on wearable inertial sensors for a drop foot assistance device

Meng, Lin and Martinez-Hernandez, Uriel and Childs, Craig and Dehghani-Sanij, Abbas A. and Buis, Adrjan (2019) A practical gait feedback method based on wearable inertial sensors for a drop foot assistance device. IEEE Sensors Journal, 19 (24). pp. 12235-12243. ISSN 1530-437X (https://doi.org/10.1109/JSEN.2019.2938764)

[thumbnail of Meng-etal-IEEESJ-2019-A-practical-gait-feedback-method-based-on-wearable-inertial]
Preview
Text. Filename: Meng_etal_IEEESJ_2019_A_practical_gait_feedback_method_based_on_wearable_inertial.pdf
Accepted Author Manuscript

Download (2MB)| Preview

Abstract

To maximise the efficiency of gait interventions, gait phase and joint kinematics are important for closing the system loop of adaptive robotic control. However, few studies have applied an inertial sensor system including both gait phase detection and joint kinematic measurement. Many algorithms for joint measurement require careful alignment of the inertial measurement unit (IMU) to the body segment. In this paper, we propose a practical gait feedback method, which provides sufficient feedback without requiring precise alignment of the IMUs. The method incorporates a two-layer model to realise simultaneous gait stance and swing phase detection and ankle joint angle measurement. Recognition of gait phases is performed by a high-level probabilistic method using angular rate from the sensor attached to the shank while the ankle angle is calculated using a data fusion algorithm based on the complementary filter and sensor-to-segment calibration. The online performance of the algorithm was experimentally validated when 10 able-bodied participants walked on the treadmill with three different speeds. The outputs were compared to the ones measured by an optical motion analysis system. The results showed that the IMU-based algorithm achieved a good accuracy of the gait phase recognition (above 95%) with a short delay response below 20 ms and accurate angle measurements with root mean square errors below 3.5º compared to the optical reference. It demonstrates that our method can be used to provide gait feedback for the correction of drop foot.